4. Installing PRRTE

4.1. For More Information

This file is a very short overview of building and installing the PMIx Reference RunTime Environment (PRRTE). More information is available in the FAQ section on the PRRTE web site.

4.2. Minimum PMIx version

The configure script in PRRTE v3.0.6rc1 must be able to find an OpenPMIx installation that is 4.2.4 or higher. If configure cannot find a suitable OpenPMIx version, it will abort with an error.

If OpenPMIx cannot be found in default preprocessor and linker search paths, you can specify the --with-pmix=DIR CLI option to tell configure where to find it.

4.3. Developer Builds

If you have checked out a DEVELOPER’S COPY of PRRTE (i.e., you checked out from Git), you should read the Developer’s Guide section before attempting to build PRRTE. You must then run:

shell$ ./autogen.pl

You will need very recent versions of GNU Autoconf, Automake, and Libtool. If autogen.pl fails, read the Developer’s Guide. If anything else fails, read the Developer’s Guide. Finally, we suggest reading the Developer’s Guide.

Note

Developer’s copies of PRRTE typically include a large performance penalty at run-time because of extra debugging overhead.

4.4. User Builds

Building PRRTE is typically a combination of running configure and make. Execute the following commands to install the PRRTE system from within the directory at the top of the tree:

shell$ ./configure --prefix=/where/to/install
[...lots of output...]
shell$ make all install

If you need special access to install, then you can execute make all as a user with write permissions in the build tree, and a separate make install as a user with write permissions to the install tree.

Compiling support for specific compilers and environments may require additional command line flags when running configure. Note that VPATH builds are fully supported. For example:

shell$ tar xf prrte-X.Y.Z.tar.gz
shell$ cd prrte-X.Y.Z
shell$ mkdir build
shell$ cd build
shell$ ../configure ...your options...
[...lots of output...]
shell$ make all install

Parallel builds are also supported (although some versions of make, such as GNU make, will only use the first target listed on the command line when executable parallel builds). For example (assume GNU make):

shell$ make -j 4 all
[...lots of output...]
shell$ make install

Parallel make is generally only helpful in the build phase; the installation process is mostly serial and does not benefit much from parallel make.